Ho boy... seats was my last update? Murf...
Shortly after the Z got dyno'd again and was showing dangerously lean numbers, too much air and not enough fuel and had to stop racing the car till that was fixed. So the next month I got this lovely doohicky.
Installed this thing and got my AFR down to respectable levels.
After that went to a cruise/meet with the Albuquerque guys to the top of Sandia Crest
http://www.youtube.com/embed/MBdK34yF1W4Short video from the run up there.
Went to a large community meet the month after, took hundreds of photos. Believe I posted a thread with highlights here...
Video from leaving it.
http://www.youtube.com/embed/0yLLlaw7XAwAfter that I got ready to move with an alignment and moved.
Unfortunately going through Lubbock Texas we needed to stop and get gas... we passed the first station outside lubbock thinking we could get gas later on, well we stopped at the next station... and missjudged the entrance to the station. It had a 3" dip followed by an 8" incline... my front bumper hit it, compressed and snapped.
zip tied and good to go haha
Finally got around to painting my rear bumper and skirts.
New brakes
http://i957.photobucket.com/albums/ae55/Jaxinc/My%20Fairlady%20Z32/Zbrakesbeforeafter350zrotors.jpgTheeeeeeeeen a few weeks ago I hydrolocked my motor going through a huge puddle that I mistook for being a small one... new pavement, after a rain, fun.
So she got torn apart, water purged, oil changed... repeatedly...
New plugs
What first drained out... gross!
Anyway she's parked currently awaiting her 6th oil change after putting 50 miles on the motor, then will repeat the 50 mile intervals until I'm sure the water is all gone.